Skip to content

Dr. Pump & Engineering Co., Ltd.

FM/UL Listed Vertical Turbine Fire Pump – VT Series | RFP

Flow: 500 – 2500 USGPM

Pressure: 57 – 256 psi

DR Pump and RFP deliver FM/UL fire pump vertical turbine solutions with fast delivery, competitive pricing, broad engine options, and strong local engineering support.

Brand:
Applications:
Fire Protection

FM/UL Listed Vertical Turbine Fire Pump – VT Series

Flow: 500 – 2500 USGPM

Pressure: 57 – 256 psi

Where water level from source supply results in a suction lift, and thus preventing the use of horizontal pumps, RFP can offer a wide range of vertical turbine pumps with drivers mounted at ground level.

DR Pump and RFP deliver FM/UL fire pump vertical turbine solutions with fast delivery, competitive pricing, broad engine options, and strong local engineering support.

Other materials are available for sea water applications.

Complete range of vertical turbine pumps is UL Listed and FM approved, designed for both electric and diesel drivers and available for 50 and 60 Hz.

Technical Data

The vertical turbine pump is divided in three distinctive sections: the pump hydraulic wet-end, the line-shaft column and the discharge head.

The pump end is composed by several stages according to the necessary generated pressure. Each stage has a bowl with an internal diffuser casted in one piece that channels the flow form one stage to the other. The shaft is guided by a double bearing rubber and bronze. The closed type impeller casted in one piece and dynamically balance ensures the highest efficiencies. It is located in place by a lock collet.

The suction casing provides the easy flow from source to the pump with the minimum lose of energy. A stainless steel strainer will prevent the debris from entering and blocking the internal part of the pump.

The column line shaft transmits the rotating power to the pump while canalizes the water from the pump to the discharge by the outside column pipe. To avoid vibration on the shaft, an intermediate rubber bearing is located in each column section. Bearings are held by bearing retainers between every two consecutive pieces of column. Shafts are coupled by a left hand threaded rigid coupling. Pumps are designed counterclockwise sense of rotation (viewed from top) and so with standard performance, the shafting tends to get tighten.

All the bearing in contact with the water are lubricated by the water being pumped up to a maximum of 40 ºC liquid temperature.

The above floor discharge head contains the discharge flange to connect with installation pipe. Head shaft is sealed by gland packing.

A right angle gear drive or hollow haft motor can be installed on the top of the discharge head easily.

The vertical turbine pump is UL listen and/or FM Approved.

Applications

  • Commercial
  • Municipal and residential high-rise buildings
  • Large industrial premises and storage warehouses
  • Offshore and remote facilities
  • Data centers
  • Airports
  • Power stations

The fire pumps are mainly used for:

  • Sprinkler systems
  • Hydrant systems
  • Water curtains

Materials

VT MATERIALS OF CONSTRUCTION

Pump End : Cast iron GG-25

Impeller: Stainless steel AISI 316

Shaft: Stainless steel AISI 420

Shaft bearing: Rubber or Bronze

Column Line Shaft: High tensile steel

Column shafting: Steel 1045

Bearing retainer: Cast iron GG-25

Bearings: Rubber

Seal by: Gland packing

Bearing lubrication: Water being pumped

Discharge head: Fabricated steel

Strainer: Stainless steel

Bolts & Nuts: Stainless steel

Downloads

Product Type

Pump Type

Fire Standard

, , , ,

Application

Brand

Country of Brand Origin

Market Area

, ,

Related Products